Lucent Technologies DDM-2000 OC-12 User Manual

SET-T3 4of2Page SET-T3
DS3ofdetectionuponfiberthetowardsinsertedisAISDS3—
DSX-3.thefromincomingLOS
NOTE:
ismoderemovalmonitorviolationtheifinsertedalwaysisAIS
forprovisioned vmr or vm.
NOTE:
If md tosetwasvalue vmr or vm tosetisitand, cc AISthe
todefaultsalways off value.
alm FailureSignalDS3incominganforlevelalarmthesetsAlarmLevel
following:theofonebemayand
cr AlarmCritical
mj AlarmMajor
mn AlarmMinor
na AlarmNo
forprovisionedissystemtheIfcritical.islevelalarmdefaultThe
LEDACTYNEthecondition,loss-of-signalaisthereandalarmno
theonLEDfaulttheandilluminated,bewillpanelusertheon
alarmtheinreportedbewillconditionTheflash.willpackcircuit
fth logarithmaoftermsinThresholdFailurethesetsFailureThreshold
tocorresponding-3,or-6eitherbemayvalueThe10.basetheto
10ofBERs
− 6
10and
− 3
-3.isvaluedefaultTherespectively.,
raised.bewillalarmancrossed,isthresholdfailuretheWhen
pmmd thisSetting(PM).performance-monitoringforusedonlyisPMMode
Thissignal.receivedortransmittedtheaffectnotdoesparameter
theifonlyappearwillparameter vmr or vm alreadyhasmode
values:followingtheofonebemayparameterThisselected.been
on value.defaulttheisThison.turnedPMDS3
off norcollectedneitherisdataPMoff.turnedPMDS3
mode.thisinreported
frame theon(PM)performance-monitoringforusedonlyisFrame
Settingpacks.circuitBBG19orBBG11/BBG11B,BBG4/BBG4B,
signal.receivedortransmittedtheaffectnotdoesparameterthis
theifonlyappearwillparameterThis vmr or vm hasmode
theofonehavemayparameterThisselected.beenalready
values:following
m13 dsx-3theandfiberthebothfromsignalDS3incomingThe
value.defaulttheisThistype.framingM13theofis
11-316 1997December1Issue OC-12DDM-2000

Lucent Technologies DDM-2000 OC-12 Specifications

General

Brand	Lucent Technologies
Model	DDM-2000 OC-12
Category	Multiplexer
Language	English