15
IDM 510-006-5
Technical Specications
English languageOperation and maintenance manual
A) Handlebar: control that drives the machine during the movement.
– The controls installed in the handlebar start the movement.
B) Feeler: it helps keeping the machine in contact with the perimeter of the load to be
wrapped.
C) Accumulator batteries: they supply the circuit and electric motors with power.
D) Battery charger: This electronic device is used to recharge the batteries C.
– To charge battery , connect the power supply cable to power outlet E.
– The charging status is shown on display of control panel E.
E) Electrical power outlet: it is used to connect battery charger to the power supply
network.
F) Control panel: it contains the devices to start and control all the operation functions.
G) Column: it is used for vertical movement of reel holding carriage H.
H) Reel holding carriage
– According to production requirements, in the ordering phase the machine can be
equipped with one of the listed carriages.
– Reel holder carriage (type M): suitable for wrapping, allows the operator to adjust the
lm tension manually using the ring nut of the mechanical brake.
– Reel-holder carriage (type FM): suitable for wrapping, allows the operator to adjust
the lm tension from the control panel.
– Reel-holder carriage (type LP): suitable for wrapping, with motorised lm pre-stretch-
ing and electronic tension adjustment from the control panel.
– Net-type reel holder carriage (type ): suitable for wrapping, allows the operator to
adjust the lm tension manually using the ring nut of the mechanical brake.
L) Document holder: it contains the use and maintenance manual.
To Next Page
Loading...
Need help?
General