53
IDM 510-006-5
Maintenance
English languageOperation and maintenance manual
Problems, causes, remedies
The table shows the list of faults that can occur during the standard operation and
it highlights possible remedies.
Table: Operation failures
Problem Cause Remedy
The display shows the message
“b0” - “b1”.
Flat battery
- Carry out battery recharge (See “Charge of
accumulator batteries”).
The machine does not start
Emergency stop button pressed
- See “Stop with activation of the emergency
button”
The bumper hit an obstacle within the
working area
- See “Stop with activation of the emergency
bumper”
Flat battery
- Carry out battery recharge (See “Charge of
accumulator batteries”).
The reel holder carriage raises but
does not stop at the top of the load
to be wrapped.
The photocell did not detect the load
to be wrapped
- Check the functionality of the component.
- The component must be adjusted (See
“Sensitivity adjustment for the product to be
wrapped detection photocell”).
The ends of the load are wrapped
with an excessive amount of
reinforcing bands.
Top reinforcing band quantity not
correctly set
- Modify the programming (See “Setup of
parameter values”).
Bottom reinforcing band quantity not
correctly set
- Modify the programming (See “Setup of
parameter values”).
The lm is too tightly stretched or
too loose.
Tension of lm not properly adjusted
- Adjust the tension of film (See “Tension
adjustment of film”).
The machine stops with the reel
holding carriage not correctly
positioned.
Presence of residues or dust on the
reel holding carriage sliding guides
- Release the safety brake of the reel holder
carriage and remove the residues.
Use brushed with soft plastic bristles.
There is an obstacle under the reel
holder carriage.
- Release the safety brake of the reel holder
carriage and remove the obstacle.
Braking or excessive wear of the reel
holder carriage lifting belt
- Release the safety brake of the reel holder
carriage and replace the component (See
“Replacing the lifting belt of the carriage”).
The noise level is too high.
The gearmotor that moves the reel
holding carriage is faulty
- Check the functionality of the component.
The gearmotor that starts the wheels
is faulty
- Check the functionality of the component.
Reel holding carriage jogging
motion.
Presence of residues or dust on the
reel holding carriage sliding guides
- Remove any residues.
Use brushed with soft plastic bristles.
The operating functions cannot be
started by using the radio control
Faulty radio control - Check the functionality of the component.
The batteries do not recharge
completely.
Faulty batteries - Replace the component.
Faulty battery charger - Replace the component.
To Next Page
Loading...
Need help?
General