41
IDM 510-006-5
Use and functioning
English languageOperation and maintenance manual
Recipe lock/unlock mode
The lock mode is used to avoid that the parameters of the stored recipes are
changed.
– The gure shows the points of intervention and the
description shows the procedures to be adopted.
1. Press and hold control H (about 7 seconds).
– Message “n. 0” appears on display E.
2. Press key D.
3. Press one of keys F until parameter “19” is displayed.
4. Press the key D to conrm.
– Display E shows message “c.9”.
5. Press key D.
6. Press one of keys F to select value “0” or “1”.
– Value “0”: recipes unlocked.
The parameters of the stored recipes can be changed.
– Value “1”: recipes locked.
The parameters of the stored recipes cannot be
changed.
7. Press the key D to conrm.
▀
Recipe function “P0”
– Recipe “P0” is used to programme the wrapping pro-
cess of a non-standard load, without changing the pa-
rameters of the programmed recipes.
– Recipe “P0” is enabled only through the recipe unlocking function.
To upload and change the recipe “P0” see “Recipe management”.
To Next Page
Loading...
Need help?
General