7
IDM 510-004-3
Safety information
English languageOperation and maintenance manual
Safety Warnings for Operation and Use
– The machine must be used by one single operator ONLY, who must be trained and
capable of performing the work and be in suitable conditions.
– Certain steps might request one or more operators, who must be previously trained
and informed on the tasks they will have to perform.
– Consult the user manual, in particular during the rst use, and make sure that you
fully understand its content.
– Find out the position and function of the controls and simulate some operations (in
particular start and stop) in order to acquire familiarity.
– The machine shall be used ONLY for the purposes and complying with the procedures
specied by the Manufacturer.
– Make sure that all the safety devices are properly installed and efcient.
– The machine should be used ONLY with the original safety devices installed by the
Manufacturer.
– Ensure the area around the machine, especially the control post, is ALWAYS unob-
structed and in good condition to minimize the risks for the Operator.
– According to the type of operation to carry out, wear the Personal Protective Equip-
ment listed in the “Instructions for use” and that indicated by the Labour laws.
– The non-compliance with the information provided herein may lead to risks for
the safety and health of the persons involved and may also lead to economic
damages.
▀
Safety Manager Obligations
– The safety manager must train the operator and help him or her familiarise and interact
with the machine in an independent, adequate and risk-free manner.
– The operator must be informed about reasonably predictable INCORRECT USES and
about the RESIDUAL RISKS that remain.
– The operator must demonstrate that he has acquired the relevant skills and has under-
stood the “User Instructions” in such a way as to carry out his activities safely.
– The operator must be able to recognise the safety signals and demonstrate that he is
in suitable condition to carry out his assigned duties.
– The safety manager must release educational material to trainees and document the
delivered training, so as to be able to produce such documentation in case of litigation.
To Next Page
Loading...
Need help?
General