49
IDM 510-006-5
Maintenance
English languageOperation and maintenance manual
Recommendations for accumulator batteries
– Connect power supply cable of battery charger ONLY to a power outlet with suitable
features.
– DO NOT connect the power supply cable of battery charger , if the values do not com-
ply with those on the machine identication plate.
– When the machine is used for the rst time with new batteries, perform a full charge
cycle.
– NEVER interrupt the battery charge cycle before it reaches its maximum capacity.
– NEVER leave the batteries in the charge station longer than the required and absolute-
ly necessary time.
– DO NOT prolong the use of exhausted accumulator batteries.
– DO NOT use naked ames and DO NOT smoke during battery charge to avoid any
risk of explosion.
– DO NOT generate sparks while installing, removing, checking, etc. the batteries to
avoid any risk of explosion.
– In case of connection to auxiliary batteries or equipment DO NOT generate sparks to
avoid any risk of explosion.
Important
These precautions must been taken because a dangerous concentration of explo-
sive gas mixtures can accumulate in the charge area.
– Connect the battery cables to those of the battery charger without inverting poles.
– DO NOT leave metallic objects between the battery poles and/or do not use them to
check the charge status to prevent the risk of any dangerous short-circuit.
– The recharging area must be arranged in ventilated premises, sheltered from weath-
ering agents and out of the operating areas.
– The installation of a charge area in a non-conforming place can generate a dangerous
concentration of explosive gas mixtures.
– Avoid discharging the batteries completely in order not to jeopardise their life cycle.
– Position the batteries in a suitable place.
The storage location should not be accessible to unauthorised persons, especially to
children, elderly and people with disabilities.
– Do not dispose of the old batteries in the environment. Carry out disposal according to
the laws in force.