Safety information
6
IDM 510-004-3
English language Operation and maintenance manual
Safety Warnings for Handling and Installation
– The manufacturer has attached special attention to the packaging of the machine, to
minimise the risks associated with the shipping, handling and transport phases.
– The personnel authorised to handle the machine (loading and unloading) must have
acknowledged technical skills and professional ability.
– Before handling, please read the instructions, in particular those on safety, contained
in the installation manual, on the packages and/or on the removed parts.
– In order to make transport easier, the equipment can be shipped with a few disassem-
bled and properly protected and packaged components.
– Loading and transport must be carried out with equipment of adequate capacity by
anchoring it to specic points indicated on the packages.
– DO NOT attempt to by-pass the instructions concerning the lifting requirements and
special points provided for lifting and handling each item and/or disassembled part.
– Slowly lift the pack to the minimum necessary height and move it very carefully in order
to avoid dangerous vibrations.
– The packs being shipped must be properly fastened to the means of transport in order
to ensure safe conditions during transfer and the integrity of their contents.
– Certain steps might request one or more operators, who must be previously trained
and informed on the tasks they will have to perform.
– Download packages in the immediate vicinity of the machine setting, which must be
sheltered from bad weather.
– Do not stack the packs onto each other in order to avoid any damage and to avoid the
risk of sudden and dangerous movements.
– In case of prolonged storage, regularly check that the component stocking conditions
do not change.
– The installation area is to be prepared so as to be able to carry out the operations as
specied in the manuals and in conditions of safety.
– Ensure that the installation environment is protected against atmospheric agents, free
of corrosive substances and free of any risk of explosion and/or re.
– Make sure that the installation area has a suitable ventilation to avoid the concentra-
tion of unhealthy air for the Operators.
– Signal and delimit the installation area in a proper way in order to prevent non author-
ised personnel from accessing the installation area.
– The connections to the power sources (electric, pneumatic, etc.) must be performed
correctly, as shown in the diagrams and in compliance with the regulatory and legal
requirements in force.
– ONLY qualied and experienced personnel are allowed to carry out the electrical con-
nections.
– After completing the connections, perform a general check to ensure that all the inter-
ventions have been carried out properly and that the requirements have been met.
– The installation manager, before commissioning, must check that all the safety devices
are properly installed and functioning.
– At the end of operations check that there are no other tools or other material near the
moving parts or in dangerous areas.
– Dispose of all packing in accordance with the laws in force in the country of installation.
– The non-compliance with the information provided herein may lead to risks for
the safety and health of the persons involved and may also lead to economic
damages.
To Next Page
Loading...
Need help?
General