Reel holding carriages
76
IDM 510-006-5
English language Operation and maintenance manual
▀
Supplying the reel with net
1. Lower the reel holding carriage until
its endstroke.
2. Lift the lever F to its vertical position.
3. Remove the cardboard core of the
reel.
4. Insert the new reel.
Check whether the wrapping lm has
the same chemical-physical proper-
ties as that installed in the reel holder
carriage.
If lm characteristics appear to be
different, consider whether you
should adjust the lm tension.
Important
In order to avoid transferring impuri-
ties to the surfaces of the guiding
rollers, discard the outer wrapping
lm layer on the reel.
5. Tie the end of the net to the base of the product to be wrapped.
6. Start wrapping.
7. Lower the lever F to horizontal position after performing at least one wrap.
▀
Adjustment of net tension
– The operation is necessary to adjust the net tension on the load to be wrapped.
1. Lower the reel holding carriage until
its endstroke.
2. Lift the lever F to its vertical position.
3. Start wrapping.
4. Lower the lever F to horizontal posi-
tion after performing at least one
wrap.
5. Adjust the net tension by means of
ring E.
– Clockwise: the value increases.
– Anti-clockwise: the value decreas-
es.
To Next Page
Loading...
Need help?
General