55
IDM 510-006-5
Maintenance
English languageOperation and maintenance manual
no. Type of failure Remedy
Reel holder carriage inverter alarms
20
The inverter parameters are not properly set
up.
- Contact the Manufacturer’s Technical Assistance Service.
21
The activation of the inverter electric power is
not correctly enabled.
- Contact the Manufacturer’s Technical Assistance Service.
22
The electric motor is damaged due to a short
circuit.
- Contact the Manufacturer’s Technical Assistance Service.
23
The heat protection is damaged because of
the overheating of the electric motor.
- Let the motor cool down.
- Press control N or deactivate and re-activate power (even more than
once) to silence the alarm.
- Replace electronic board if the alarm persists.
27
Communication was interrupted because of an
internal error.
- Contact the Manufacturer’s Technical Assistance Service.
Reel holding carriage (type LP) inverter alarms
30
The inverter parameters are not properly set
up.
- Contact the Manufacturer’s Technical Assistance Service.
31
The activation of the inverter electric power is
not correctly enabled.
- Contact the Manufacturer’s Technical Assistance Service.
32
The electric motor is damaged due to a short
circuit.
- Contact the Manufacturer’s Technical Assistance Service.
33
The heat protection is damaged because of
the overheating of the electric motor.
- Let the motor cool down.
- Press control N or deactivate and re-activate power (even more than
once) to silence the alarm.
- Replace electronic board if the alarm persists.
37
Communication was interrupted because of an
internal error.
- Contact the Manufacturer’s Technical Assistance Service.
Battery charger alarms
40 Battery charger is damaged.
- Remove hood , disconnect battery charger and then reconnect it.
- If the alarm persists, replace battery charger.
47
Communication was interrupted because of an
internal error.
- Contact the Manufacturer’s Technical Assistance Service.
To Next Page
Loading...
Need help?
General