MA NC-6000 - Maintenance Mode

Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 13 -
Chapter 4 Maintenance Mode
Maintenance Mode is for testing and maintaining NC-6000 only. Please follow
the instruction as below when operating under the mode, or there is a risk to
damage the device.
How to enter Maintenance mode:
1. Turn on the device.
2. Press and hold the “ ” and “
” keys
together on the initializing page.
3. The device enters the Maintenance mode
automatically.
4. After enter the test mode, use the following keys to
operate:
 F1: Move Up.
 F2: Move Down.
 : Toggle between options and/or confirm a
selection.
 : Go back to upper layer/Stop.
F1
F2
F3