MA NC-6000 - Test Encoder; Burn in; Test SD; Turn to the Back Side of the Device and Insert the SD Card

Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 28 -
4.6.13 Test Encoder
Testing the functionality of encoder.
1. Highlight the option and press “ ” key. The
motor starts running a certain time.
2. A number of Encoder is shown on the left side of
the option. The shown number of encoder during
every test should be similar.
Burn In
To burn in the entire device. [Factory used only].
1. Highlight the option and press “ ” to enter
the burn in mode.
2. Press “
” to burn in the entire device
(Motors, rollers.etc) which will can keep the
functionalities of
machine in a stable
situation.
3. Use “F1” and “F2” key to set the burn in time,
and press “ ” to activate. Motors and rollers
keep running while burn in is under
processing.
4. Press “
” to stop the burn in function and
press “ ” again to go back to the upper
layer.
4.6.15 Test SD
Test the functionality of SD interface.
Turn to the back side of the device and
insert the SD card.
1. Highlight the “Test SD” option and press
“ ”.
 The following are the definitions of different
numbers.