Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 23 -
*Note: Initialization shall only be executed with indication
from MA.
1.
Press the “ ” key for the initialization and the
display shows “Wait…”. Do not touch any button
and wait until the process is finished.
2. Once the initialization process is done, the display
shows “Init OK”.
3. Calibrate the device immediately.
4.5 IR Mode
To check the status of IR sensors and triggers.
4.5.1 IR Status
To see the IR triggers’ reactions.
1. In normal status, only the channel P2-Sol shows
reaction curve.
To Next Page
Loading...