MA NC-6000 - Detection Level; Count Mode Intensity; Printer Type; Hpr Trigger Detection Mode

To Next Page

To Previous Page

Service Manual – NC-6000 Date: OCT 1

, 2012 (Version 1.0)

Masterwork Automodules Tech. Corp., Ltd

Confidential

- 31 -

4.8.3 Detection Level

1. Highlight the “Count Mode-

Light intensity” and

change the level of intensity 0(low) to 3(high) in

count mode by pressing “ ”.

Note: It’s suggested to use default setting on the device.

Value of initialization should be 0.

4.8.4 Count Mode Intensity

This function does not exist in NC6000.

4.8.5 Printer Type

Set up the printer type

Highlight the “Printer Type” and change

the printer type by pressing “ ”.

There are two printer type option can be

set. Use “F1” and “F2” keys to select the

desired printer type and press “ ” to

switch the setting.

*Printer types:

-Thermal Printer

-Dot-Matrix Printer

Note: Be aware which type of printer is connected to

the device before changing the setting.

4.8.6 Hpr Trigger Detection Mode

Set up the Detection Mode to enable the Calibration Hpr function in IR Mode

1. Highlight the option and change the detection

mode version by pressing “ ”.

Note: Calibration Hpr function can only be operated

in Hpr Trigger Detection Mode V2.