MA NC-6000 - Upgrade Mode

Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 18 -
1. Place a bundle of 50 pcs test notes
(Denomination: 1USD) on the hopper and pull the
hopper guide to fix the size of test note. The
machine starts running once it detects notes on
the hopper.
Note: The distance of two sides from hopper to the edge of
banknote shall be around 3mm to 5 mm.
2. Press the “ ” to activate the solenoid & Brake
function.
The machine counts and the solenoid toggles between
reject pocket and stacker. Check the two pockets to
make sure that banknote are separated equally in both
pockets.
*Note: If the Solenoid & Break doesn’t function well, please
contact MA.
4.3 Upgrade Mode
Using supported devices to upgrade NC-6000.
1. Insert SD card with upgrade firmware into the
device.
2. Highlight the “SD” and press “ ” to enter the
upgrade mode.
3. Once SD card is detected, a green mark
shows next to the “Show Ver” option.