MA NC-6000 - Reject Pocket Stoppers; Stacker and Reject Pocket

Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 61 -
5.3.3.1 Stacker and Reject Pocket
1. Loosen the two screws (Ø3x8-Countersunk) ob the both
sides of the stacker module.
2. Release the reject pocket plate from the assembly.
3. The reject pocket is removed from the stacker module.
5.3.3.2 Reject Pocket Stoppers
1. Get the reject pocket plate which is disassembled from
the stacker module.
2. Release the shaft from the reject pocket stopper with the
indicated direction.
3. The stopper and the spring are now free to be removed.
*Note: The right and left stopper are not the same, please
notice the mark on the stopper as the picture below.
Right Side
Left Side
R L