MA NC-6000 - Page 60

Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 60 -
1. Lay down the machine and loosen the four screws
(Ø3x8-Countersunk) on the bottom of the machine.
2. Release the stacker stopper and stacker static plate from
the stacker module.
3. Pull out the stacker module straightly and slowly.
*Note: There are few cables connected between the stacker
module and the PCS boards.
4. The stacker module is now removed from the machine.