Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 19 -
4.3.1 SD Upgrade
Before upgrade the SD card.
1. Get a folder with upgrading firmware and database from MA.
2. Put the folder into SD card with the folder name “_SD_Upgrade”.
*Note: (1) File system must be FAT32, other type is not supported.
(2) File name must be “_SD_Upgrade”.
To upgrade the device with a SD card.
1. Once a SD card is detected, a green mark is
shown next to “Show Ver” and the device is
available to be upgraded via SD card. If not, a red
cross is shown instead.
2. Highlight the desired option and press “
A mark shall be shown next to the upgraded
module. The following are the definitions of the
status.
: On the process of upgrading module.
: The module has been upgraded correctly.
: Upgrading process is failed.
4.3.1.1 Show Ver
To check the available and currency firmware version.
1.
The current module version and the available
version on the SD card can be checked here.
2. The following are the definition of different signs.
: A new version is found.
: Firmware data cannot be found.
: The same firmware as current version has been
detected.
: The available version is older than current
firmware is detected.
To Next Page
Loading...