MA NC-6000 - PCB NC6000-DTE Board

Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 65 -
2. Disconnect the indicated cable from the connector.
3. Pull out slowly the bottom conveyor plate.
*Note: If it results dificulty when pulling out the bottom
conveyor plate, please check if the cable has been
released.
The bottom conveyor plate has been removed from the
machine.
5.3.4.2 PCB NC6000-DTE Board
1. Loosen the two screws (Ø3x8-Round Head)
on the
NC6000-DTE board.
2. The NC6000-DTE board is now removed from the
machine.