Why does my Mahr Measuring Instruments say 'Connect AC adapter to RD18!'?
If the 'Connect AC adapter to RD18!' message appears on your Mahr Measuring Instruments, the RD 18 battery is empty. Connect the AC adapter to the RD 18 and load the battery.
What does 'ACK not received!' mean on Mahr Measuring Instruments?
If you see 'ACK not received!' on your Mahr Measuring Instruments, the M 300 is attempting to set up a Bluetooth connection with an RD 18 but cannot establish a connection. Switch on first the RD 18 and then the M 300 and wait until the M 300 has established the connection.
What to do for a drive unit error on Mahr Measuring Instruments?
If you encounter a 'Drive unit error' on your Mahr Measuring Instruments, it indicates that the feed drive of the drive unit is defective. If this appears repeatedly, send the instrument in for repair.
General| Measuring Principle | Inductive |
|---|---|
| Resolution | 8 nm |
| Probe Tip Radius | 2 µm |
| Measuring Force | 0.75 mN |
| Storage Temperature | -20°C to 70°C |
| Resolution (nm) | 8 nm |
| Resolution (µm) | 0.008 µm |
| Power Supply | Battery or mains |
Covers reading documentation, specific use, avoiding hazards, and proper handling.
Describes how measured profiles are analyzed and evaluated using various parameters.
Instructions for charging the internal batteries of the MarSurf M 300 and RD 18.
Procedures for configuring instrument parameters and standards.
Covers selecting standards, managing timeout functions, and blocking settings with a code.
Details measurement and evaluation conditions according to ISO, ASME, and JIS standards.
Details measurement and evaluation conditions according to the MOTIF standard.
How to select parameters and set tolerance limits for evaluation.
How to assign functions to the programmable F1 and F2 keys.
Steps to set up the instrument for mobile operation.
Guide for mounting and setting up the instrument for stationary use.
Procedure to select the correct pick-up type and its measuring range.
Steps to establish a wireless Bluetooth connection between devices.
Instructions for performing surface texture measurements with the instrument.
Describes how to interpret and analyze measurement results.
Lists all parameters that can be calculated and evaluated by the instrument.
Guide on how to save measured profiles to the internal USB memory.
Instructions for saving measurement results and sequences.
How to manually enter a correction value for the pick-up.
To Next Page
