Manitowoc Published 12-05-17, Control # 035-23 3-29
18000 SERIVCE/MAINTENANCE MANUAL ELECTRIC SYSTEM
Abbreviations
The following abbreviations are used in this section:
AC = Alternating Current I/O = Input/Output
A/C = Air Conditioning L.E.D. = Light Emitting Diode
AI = Analog Input Max. = Maximum
AO = Analog Output Min. = Minimum
CAN = Controller Area Network MS = Motor Starter
CANH = Controller Area Network - High N/A = Not Applicable
CANL = Controller Area Network - Low N/C = No Connection
CHA or CHB = Channel A or B NO = Number
DC = Direct Current NS = Node Select
DI = Digital Input Opt. = Optional
DO = Digital Output psi = Pressure
EC = Encoder Control RCL = Rated Capacity Indicator/Limiter
ENC = Encoder Number Count V = Volt or Volts
FCN = Front Console Node VDC = Volts Direct Current
GND = Ground W = Wire
ID = Identification
To Next Page
Loading...
