Maple Systems Silver Series - Page 60

4The make same height command
1. Select the objects you wish to make the same height. For this example, select the left and
center rectangle objects of Window_12
2. From the Edit menu, click Make Same Size, then Height or click the appropriate icon from
the Manager toolbar.
 EasyBuilder always uses the height of the last object that was created as the basis for
the height. In this example, the left rectangle was created first, then the middle
rectangle, finally the right rectangle. See what happens when the make same height
command is applied to the center and right rectangles.
4The make same size command
1. Select the objects you wish to make the same size. For this example, select the left and center
rectangle objects of Window_12
2. From the Edit menu, click Make Same Size, then Both or click the appropriate icon from the
Manager toolbar.
 EasyBuilder always uses the size of the last object that was created as the basis for the
size. In this example, the left rectangle was created first, then the middle rectangle,
1010-1001a, Rev 02
56 Sil ver Se ries In stal la tion & Op er a tion Man ual