174
9.7. Geofencing alarm (MMSW0006 license)
SW License MMSW006 activates support for a dedicated pin for geofencing
zone violation. Instead of reading the stream of location data in the protocol, it
is now possible to have just a pin from the 4X4 of Super-Beacon or pins on
the modem or internal pins in the Mini-RX to be automatically switched to “0”
or “1”, on every time reset, when the geofencing zone rules are violated.
Supported hardware:
- Super-Beacon
- Modem v5.1
- Mini-RX
Follow instruction bellow to use this feature:
9.7.1. Connect alarm to your devise according to scheme:
9.7.1.1. Geofencing pin scheme for Super-Beacon (when license activated SPI
will not be available):
To Next Page
Loading...