53
3.6.6. Industrial Super-Beacon Metal-25kHz
Do not disassemble the Industrial beacons. Otherwise, warranty will be lost
- Supports dual-use – RX and TX beacon.
It can transmit on its native ultrasonic
frequency (25kHz) and it can receive on
any ultrasonic frequency via an
embedded RX sensor – like Industrial-
RX or Mini-RX does. Effectively, the
Industrial Super-Beacons beacons
combines inside an Industrial-TX and
Industrial-RX. Additionally, the beacon
supports both AI and NIA architectures.
Thus, it is called Industrial Super-
Beacon
- Electronics is IP67 protected
- Special IP67-protected 25-kHz transducers
- External antenna with SMA connector for extended radio range
- Corresponding IP67 connectors (male part) included
- No battery inside
- Extended working temperature range from -40°C to +50°C (not tested, provided by
design)
- Embedded reset switch and DFU switch – magnetic control
- Two IP67 external connectors:
- Modification (After April 2022)
- Version 3 of Industrial RX (from April 2022) supports ONLY +5V power supply. Don’t
use +12V power supply converter for this version, it will burn the beacon!
- This version doesn’t have UART RX, but now is possible to use Interface connector as a
power supply.
- RS485 modification pinouts
- Can work together with modems with corresponding radio (radio bands must match)
- Can work with any Mini-RX beacon or Beacon HW v4.9 with 25kHz ultrasonic
sensors (radio bands must match)
To Next Page
Loading...