52
Uploading Beacon’s Industrial-RX or Beacon’s Industrial-TX SW to Industrial
Super-beacon may permanently damage Industrial Super-beacon board.
Determine carefully the version of your Industrial beacons: it may
be built before September 2019 and after September 2019. If it
is beacon from the late batch, you must use Industrial Super-
beacon SW. if you have beacons from the early batch, use
Industrial-RX or Industrial-TX SW. Stickers’ differences: Later
batch – Ind-RX-S or Ind-TX-S. Early batch – Beacon Ind-RX or
Beacon Ind-TX.
Version 2 and 3 of Industrial-TX-Metal (from June 2022)
supports ONLY +5V power supply. Don’t use +12V power
supply converter for this version, it will burn the beacon!
This version doesn’t have UART RX, but now is possible to use
Interface connector as a power supply.
To Next Page
Loading...