MASSO G3 User Manual

MASSO
MASSO Documentation
9.6. M04 – Spindle ON (Counter Clockwise)
This command starts the spindle in counter clockwise direction at the RPM set by the S command
Syntax & Parameters
M04 - Clockwise command followed with or without S value.
S - The S value defines the required RPM. If the S value is not given then the last S value is
automatically used.
Example program
N10 M04 S1200
In this example the spindle is started in counter clockwise direction at 1200 RPM.
v5.18 - 08 Apr,2021
www.masso.com.au Page 241 of 477

MASSO G3 Specifications

General

Storage	8GB eMMC
Connectivity	Ethernet, USB
Power Supply	24V DC
Isolated Inputs	16
Isolated Outputs	8
Relay Outputs	2
Encoder Inputs	4
Step/Direction Outputs	6
Analog Inputs	2
Digital Inputs	16
Digital Outputs	8
Humidity	10% to 90% non-condensing
Display	7-inch touchscreen
Axes	Up to 6 axes
Spindle Control	PWM, Analog, or Step/Direction
Software	MASSO OS
Operating Temperature	0°C to 50°C
Storage Temperature	-20°C to 70°C
Memory	1GB RAM
Output Current	500 mA per output