MASSO
MASSO Documentation
9.13. M10 – Chuck Or Rotary Table Clamp On
This command turns On the Chuck Clamp output.
CAUTION: For safety, output LOW means the clamp is On and an interlock signal from the spindle
drive must be wired for safety so that the clamp does not open while the spindle/chuck is spinning.
Syntax & Parameters
M10
Example program
N10 M10
In this example the Chuck Clamp is switched On.
v5.18 - 08 Apr,2021
www.masso.com.au Page 249 of 477
To Next Page
Loading...
