MASSO
MASSO Documentation
9.22. M98 & M99 – Sub Program Call
MASSO supports Sub-Program Call using M98 & M99 codes. Subprograms with upto 5 levels of nesting is
supported, with this feature sub programs can be called from the main program without the need to rewrite
the same program again and again.
When a sub program is called, MASSO looks for a separate ".nc" file and runs that as a sub-program.
Having a separate file approach means that programs that have common features can now be used used
with other programs.
INFORMATION: All sub-program files must be on the root folder of the USB Flash drive.
INFORMATION: Loading a subprogram directly, not via a sub-program call, will cause MASSO to
hang.
INFORMATION: Subroutine toolpaths are not drawn on the screen during program load.
M98 Sub-Program Call
v5.18 - 08 Apr,2021
www.masso.com.au Page 258 of 477
To Next Page
Loading...
