9.3 ECB (ELECTROMAGNETIC BRAKE) REMOVAL AND INSTALLATION
1. Turn o power and disconnect the cord from the machine.
2. Remove both front disks and plastic shrouds from machine as
outlined in section 9.1. (Figure A).
3. Unplug ECB (under mast connection point) from wire harness.
(Figure B)
4. Loosen 11mm nut on tension loop bolt. (Figure C)
5. Remove tension loop bolt from ECB bracket. (Figure D)
6. Remove the 6 bolts holding the ECB to the frame & remove the belt
once loose. (Figure E)
Figure A
Figure C
Figure D
Figure E
Figure B
CHAPTER 9: PART REPLACEMENT GUIDE
28
To Next Page
Loading...
