33
1. Turn o power and disconnect the cord from the machine.
2. Remove the console and disconnect the heart rate wires as outlined
in section 9.9.
3. Remove the two screws holding the plastic handlebar cover in place
and remove the cover. (Figure A)
4. Remove the 4 bolts that hold the handlebar to the mast being
careful to support the handlebar. (Figures B and C)
5. Carefully remove the wires from inside the mast until the
connectors on the ends come free and disconnect. (Figure D)
6. To install, carefully push the heart rate wires into the mast and pull
them out to reach the console. Reverse steps 1-4 to reassemble
and test machine as outlined in section 9.99.
9.6 FIXED HANDLEBAR REMOVAL AND INSTALLATION
Figure A
Figure B
Figure C
Figure D
CHAPTER 9: PART REPLACEMENT GUIDE
32
To Next Page
Loading...
