35
9.8 CONSOLE REMOVAL AND INSTALLATION
1. Turn o power and disconnect the cord from the machine.
2. Remove the 4 screws that hold the console to the top of the mast.
(Figure A)
3. Disconnect the data cable, heart rate, and ground wires. (Figure B)
4. Attach the wires to the new console, heart rate wires are labeled R
and L.
5. Carefully push the wires into the console and mast until they are
clear of the console/mast connection and attach the console to the
mast using the 4 screws.
6. Plug in and test the machine as outlined in section 9.99.
Figure A
Figure B
CHAPTER 9: PART REPLACEMENT GUIDE
To Next Page
Loading...
