Matrix MX-A5x - Swing Arm Removal and Installation - Continued

46
9.13 SWING ARM REMOVAL AND INSTALLATION - CONTINUED
Figure F
Figure G
Figure H
Figure I
5. To remove the swing arm from the machine, loosen one of the bolts
on either side of the upper pivot joint. (Figure F)
6. Holding onto the swing arm, push /pull the pivot shaft out of the
bearing housing. (Figure G and H)
7. Transfer the rubber arm pad and plastic parts to the new swing
arm. (Figure I)
8. Reverse steps 1-6 to reassemble unit, when reassembling be aware
of the spacer between the bearings that the shaft passes through.
(Figure J) Test machine as outlined in section 9.99.
Figure J
CHAPTER 9: PART REPLACEMENT GUIDE