McHale Fusion 3 Baler & Wrapper
73
Tip not complete
If “Stop” (Button 1) is pushed during the tipping of a bale,
this error is displayed when the control box is next switched
to “Auto”. To correct the error push “Tip Bale” (Button 13) to
complete the tipping cycle. Pushing ESC (Softkey D) on the
control box will cancel the error warning.
Unblock
This is not really an error message but it signifies that unblock is active. A quick push
on “Reset unblock” (Button 10) on the control box will restore everything to a working
condition.
Lube count
An alarm is provided to remind the operator to change the
grease cartridge and top up the lubrication oil after a preset
number of cycles. This counts down from 300 and gives a
reminder at zero. Press “Reset” (Button 10) to clear the
warning. It may be reset sooner, if desired, from within the
bale count menu. (See Section “Bale Count” on page 69)
Knife pressure too high
This tells the operator that the hydraulic pressure holding up
the chopping knives is too high for baling which could lead
to knife or machine damage. This warning will be seen if
manually raising the knives with max pressure, (See
Section “Knives Operation” on page 62)
Unblock Reset unblock
To Next Page
Loading...
