EasyManua.ls Logo

McHale HS2000 - Noise Level; Fire Precautions; Special Safety Devices;Instructions

McHale HS2000
91 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
McHale HS2000 Round Bale Wrapper
19
recommended maximum working time of hoses should not exceed 5 years.
Only use exact specification McHale genuine replacement parts.
As the cut and hold is kept closed by gas accumulator pressure, it is
necessary to release this before removing the accumulator or working on the
hydraulic cylinder. Otherwise injury may occur. If in doubt entrust the job to
your McHale dealer.
Do not work on hydraulic systems unless you are qualified to do so. This work
should only be carried out by qualified persons or your McHale dealer.
4.3 Noise level
The European Regulation 86/188/EEC directs employers and employees to
control the noise level at work. The noise level at field work may differ
according to the tractor, ground, crops and other environmental conditions.
In normal conditions, whilst driving the McHale HS2000, the noise level to the
driver’s ear does not exceed 70 dB (A) with the rear screen of the tractor
cabin open. The common noise level of the machine and the tractor is
primarily influenced by the tractor noise (radio is an additional noise source). It
is recommended to operate this machine with closed cabin windows.
4.4 Fire precautions
Be aware that crops are easily inflammable.
Do not smoke or make use of any open fire next to the machine.
A functioning fire extinguisher should always be available on the tractor.
The machine is to be kept clear of oil, grease, crops, string, plastic or any
other flammable material at all times.
Do not continue to work with overheated parts, cables or pipes, unless you
have identified and eliminated the reason for overheating.
4.5 Special safety devices/instructions
The owner of the machine is obliged by law to ensure that all safety devices
are installed on the machine and are in good functioning condition.
Always use protective gloves when replacing knife blades in the cut and hold.

Table of Contents

Related product manuals