McHale HS2000 Round Bale Wrapper
45
7.5 Electronic control box features
7.5.1 Working display
When the electronic control box is first switched on it displays Expert Series, followed
by the program version number, followed by the selected language. The working
language can be changed at this point if necessary. The language is changed by
pressing Display Up (button 1) or Down arrow (button 4) to scroll to the desired
language when the default language “English” is displayed.
After a short delay the working display (screen 1 of 3) appears. There are three different
working screens. Press Enter (button 3) to toggle between the three screens.
Main working screen
The main screen shows the machine status, manual or automatic, the current
wrap count, and the preset number of wraps.
Second working screen
This screen shows the total for the selected bale counter.or the voltage and the
wrapping speed in rpm.
Third working screen (does not apply to newer machines)
This screen shows the the steering angle indicator.
7.5.2 Counters
The Expert Series electronic control box contains the following counters:
Ten different bale counters (A - J), which can be reset. These bale counters
can be used to measure the amount of bales wrapped for various customers
by using a different counter for each customer.
Grand total counter, which cannot be reset. Every bale that is wrapped by
the machine is added to this counter.
NOTE: Previous settings
If the continuous cycle option was selected in the previous cycle, the
electronic control box asks you to confirm these settings by pressing
Enter (button 4).
If the Auto Parked function was selected in the previous cycle, press
Enter (button 4) to Auto Unpark. Before you select Auto Unpark, move
the drawbar and film roll holder into the working position.
To Next Page
Loading...
