McHale HS2000 Round Bale Wrapper
54
8
Wrapper Operation
8.1 Preparing the machine for wrapping
1. Move the film holder to the working
position, see section 10.12.
2. Turn on oil supply.
3. Remove drawbar transport lock and put it
into working position slot as shown.
4. Then, adjust drawbar to the desired
working position. Do not operate the
hydraulic cylinder with the road transport
lock in position.
5. Switch on electronic control box.
6. Check operation of dispenser safety arms
by attempting to rotate dispensers when
arms are in tripped position. Carry out this
test on each dispenser arm.
7. Ensure wrapping table is tipped in the fully forward position.
8. The machine is now ready to wrap.
WARNING: Keep out of the “Danger Zone”
Keep all persons, especially children, outside of the “Danger Zone”
during all machine operations! See “Danger zone” on page 14.
WARNING: Do not carry people or animals on the machine
The operator must ensure that no persons or animals are carried on the
machine at any time or are hidden under the machine (on the tractor
persons are only allowed to sit on the relevant seats).
ENVIRONMENT: Recycling of the plastic film
Respect the environment! Never dump or burn waste plastic film. It is
toxic! Always take waste materials to a recycling centre.
To Next Page
Loading...
