McHale HS2000 Round Bale Wrapper
59
9
Road Traffic Safety & Operation
9.1 Before travelling on any public roadway
The following should be inspected every time, before travelling on a public road:
All bales, wrapped or unwrapped, should be unloaded from the machine.
Slowly move the drawbar manually to
transport position by means of the
hydraulic lever as shown; then, remove the
lever and replace it in the hole provided on
the valve guard.
Move film holder to the ‘road transport’
position, ensuring that both top and bottom
spring bolts are both fully engaged in the
correct slot (see section 10.12).
NOTE: Check lighting system before travelling on the road
Before travelling on a public road, the operator must ensure that the
complete (tractor and machine) lighting system is in a fully functioning
condition.
WARNING: Complete a full inspection before travelling on the road
Ensure that a full inspection is completed every time before attempting
to go on to a public roadway, always think and practice safety!
NOTE: Control box
Before travelling on a public road, always make sure that the electronic
control box is switched off.
To Next Page
Loading...
