McHale HS2000 - Page 60

McHale HS2000 Round Bale Wrapper
60
 Bring the wrapper into park position by pressing Auto Park (button 14) on the
control box, ensuring that the film holder is in the transport position.
 Affix the safety bar into the appropriate
position as shown. Position 1 applies to
machines attached directly to a tractor.
Position 2 shows the safety bar position,
when the wrapper is in ‘combi’ mode, i.e. in
use with the baler.
 The dispensers must be swung around so
that they are inside the transport width of
the machine.
 Ensure that the tyres are set to the correct
pressure as per safety decals and
according to the specifications, as outlined
in section 2.3.
 The lighting system of the machine must be connected to the tractor and must
be in a fully functioning condition.
 Ensure the oil supply is turned off and cannot be turned on accidentally.
 The electronic control box must be switched off or disconnected from the
power supply, see “Electronic control box functions” on page 43.
 The hydraulic supply must be turned off and protected from accidental
activation by disconnecting the hydraulic feed line. Support all loose lines in a
safe manner.
 Attention must be paid to the maximum travel speed-limit (40 km/hr) printed
on the chassis plate, on the left hand side of the machine. Other speed limits
that may be printed, on the drawbar plate or axle plate, for example are not
relevant.
 If plastic film is to be transported on the machine it must only be done so on
the holders provided and secured if necessary. If plastic film is left in the
dispensers during transport, ensure that it is pushed away from the aluminium
rollers.
 Ensure that all the national road traffic regulations relating to the country are
fulfilled i.e. the use of safety chains may be mandatory in certain countries.