McHale HS2000 - Attaching the Wrapper to Baler; Lighting System

McHale HS2000 Round Bale Wrapper
30
7. Screw the 37 pin socket on the electronic box onto the 1.5 m extension cable
and in turn onto the 37 pin plug on machine. Ensure that the cable to the
machine is not under tension and clear of sharp edged etc.
8. Connect the control box to the tractor battery using the fused electric power
cable provided (preferred option), or to the euro socket of the tractor, ensuring
to route away from sharp edges and hot surfaces. There must be a good 12 V
supply to the control box.
9. Check that all of the above functions operate correctly.
10. The machine is now ready to work.
5.5 Attaching the wrapper to baler
1. Reverse tractor and baler up to the wrapper, lining up the hitch of the baler with
the hitch of the wrapper.
2. Fit tow pin to hitch ensuring it is secure.
3. Screw jack up off the ground, remove locking pin and turn jack into transport
position. Secure locking pin.
4. Connect the hydraulic connections as described in section 5.9.
5. Plug the 7 pin lighting plug into the socket on the baler which in turn is
connected to the 7 pin socket on the tractor.
6. Place the electronic box in the tractor cab and secure to the glass in an
appropriate place using the suction pad on the rear. Safety strap must be
secured to protect box from accidental damage. If there is no cab on the tractor
secure as appropriate bearing in mind the box is not waterproof.
7. Screw 37 pin socket on baler and 37 pin plug on machine together. The loom
on the baler should be attached to the electronic control box.
8. Connect control box to tractor euro socket or battery using the power cable
provided. The supplied battery power cable is the preferred option. There must
be a good 12V supply to the control box.
9. The camera (if fitted) is situated on an appropriate position on the baler and
must be connected to the monitor in the tractor.
10. Check that all functions operate correctly.
11. The machine is now ready to work.
5.6 Lighting system
The 7 pin plug of the lighting system on the machine must be connected to the 7 pin
socket on the tractor
NOTE: Check lighting system before travelling on the road
Before travelling on a public road, the operator must ensure that the
complete (tractor and machine) lighting system is in a fully functioning
condition.