McHale HS2000 - Cut and Hold Operation, Lower Ram

McHale HS2000 Round Bale Wrapper
83
14.7 Cut and hold operation, lower ram
Symptom Reason Solution
Cut and hold assem-
bly does not rise
No oil feed Turn on oil and check the quick
release coupling (ensure oil
feed is set at 35l/min.)
No oil return Ensure that the “tank return”
line is connected “to tank” and
check quick release coupling.
Check tractor manual for
hydraulic connections on trac-
tor.
Electrical power supply
fault, e.g. loose connec-
tions, poor battery and/or
charging system
Ensure that a 13V supply is
available and check all electri-
cal connections
This function is not possi-
ble in MAN cycle.
The cut and hold will only rise
in an AUTO cycle, switch to
automatic cycle, see section
7.4, Menu Structure.
Cut and hold will not
lower
No oil feed Turn on oil and check the quick
release coupling (ensure oil
feed is set at 35l/min)
No oil return Ensure that the “tank return”
line is connected “to tank” and
check quick release coupling.
Check tractor manual for
hydraulic connections on trac-
tor.
Electrical power supply
fault, e.g. loose connec-
tions, poor battery and/or
charging system
Ensure that a 13V supply is
available and check all electri-
cal connections