McHale HS2000 - Page 46

McHale HS2000 Round Bale Wrapper
46
Select and set a bale counter (A-J)
1. From the working display, press Display Down (button 4) once to see the To
Change Total display.
2. Press Enter (button 3) to move to the To Select Total display.
3. Select desired counter (A -J) using Display Up and Display Down (buttons 1
and 4).
4. When you reach your desired counter, press Enter (button 3) to select it.
5. Press Display Up (button 1) or ESC (button 2) once to return to the working
display.
Reset the current bale counter (A-J)
1. Press Display Up (button 1) once, from the main working screen.
2. The current bale counter total will be displayed.
3. Press Enter (button 3) to reset it.
4. Press Display Down (button 4) or ESC (button 2) once to return to the working
display.
View the grand total bale counter
1. To view the grand total bale counter, press Display Up (button 1) twice, from
the main working screen.
2. The grand total counter will be displayed.
7.5.3 Voltage monitor
The Expert Series electronic control box monitors its operating voltage and displays it
during wrapping. If the voltage falls below a safe level “LOW BATT” is flashed on the
display. The usual causes of low voltage are:
 A bad battery
 A defective charging circuit
 Loose or corroded connections
 Fuses or a faulty power lead to the control box
7.5.4 To set wraps
1. To change the desired number of film wraps, press Display Down (button 4)
twice to display the To Set Wraps screen.
2. Press Enter (button 3) to move to the Use To Set screen.
3. Use Display Up and Display Down (buttons 1 and 4) to make changes to the
flashing figure. When correct figure shows press Enter (button 3). The second
digit is programmed in the same way.
4. When the desired figure is displayed, return to the working display by pressing
ESC (button 2) or Display Up (button 1).