McHale HS2000 - Page 89

McHale HS2000 Round Bale Wrapper
89
Pre-delivery inspection form
A signed copy of this form is to be retained by both the Dealer and the Customer.
CLT00466
PRE-DELIVERY INSPECTION (PDI)
HS2000 Round Bale Wrapper
Castlebar Road, Ballinrobe, Co. Mayo
Tel: +353 (94) 95 20300 Fax: +353 (94) 95 20356
E-mail: sales@mchale.net Web: www.mchale.net
DEALER:.................................................... Model: HS2000 Round Bale Wrapper
Full Address:............................................... Serial No:..........................................................
.................................................................... Date Delivered:.................................................
Fitter:........................................................... Date Inspected:.................................................
CUSTOMER:...............................................
Full Address:............................................... Tel:....................................................................
.................................................................... Mobile:..............................................................
.................................................................... E-mail:...............................................................
ENSURE THAT THE TRACTOR IS OF THE CORRECT SPECIFICATION FOR THIS MACHINE
REFER TO THE OPERATOR INSTRUCTOR MANUAL BEFORE MAKING ANY ADJUSTMENTS!
1. Check that all accessories are with the Owner/
Operator. Check Operator Instruction Manual
and Parts List.
11. Check that dispenser trip arms work.
2. Ensure machine is re-assembled correctly.
(Refer to all assembly instructions supplied)
12. Check the dispenser rotation speed. Warning:
Max 30 rpm.
3. Ensure that the wheels are correctly fitted (i.e.
valve to the outside). Torque wheel nuts
correctly.
13. Ensure plastic is applied to the centre of the
bale.
4. Check for correct tyre-type, tread and
pressure. (Tyre inflation pressure is 1.75 BAR
or 26PSI)
14. Check that dispensers are running smoothly &
free from damage or grit.
5. Adjust drawbar to ensure wrapper is parallel
to the ground when coupled to tractor/baler.
15. Run the automatic programme on the control
unit.
6. Hitch machine to tractor/baler. Set
transportation bar and ensure all pins are
secure. Attach 7pin plug for lighting system.
16. Check that all electrics and lights function
correctly.
7. Connect hydraulic hosing to tractor ensuring
proper hydraulic setup. See section 6. Note:
Ensure free flow return to tank.
17. The operator must be fully aware of all
hazards, controls (electric & hydraulic), all
functions & safety devices of both the machine
and the tractor.
8. Ensure control-unit power supply is 12v direct
from battery otherwise the machine may
malfunction.
18. Ensure that the owner/operator reads the
operator instruction manual and understands
fully all safety & operating aspects of the
machine as described.
9. Ensure the control-unit is on the correct
programme (Combi / Trailed). Check all
manual functions from the control unit.
19. Instruct operator on machine maintenance i.e.
Check chain tensions, adjustments, tyre
pressure and wheel nuts, also areas to be
greased daily along with other routine
functions.
10. Adjust drawbar-swing/safety transportation-
bar, to suit trailed or combi arrangement.]
I am satisfied that the above checks have been carried out, and that the machine is complete with all accessories and manuals.
Signed:............................................................................... (Dealer) Date:..............................
Signed:............................................................................... (Owner) Date:..............................
This machine must be registered on www.mchale.net by the Dealer in order to quality for Warranty!