Medicomp TelePatch PM750 - Error Indicators

Have a question or need assistance?
Call Medicomp’s Patient Support: 877-996-5553
Symptom Recording
Complete on Cables or Patch
“Recording Complete” message
will be seen on screen of
Handset
None
Finger Tip Electrodes Start of
Recording
Green LED 3 flashes 0.5 second
each then Green LED lit for 1
second
Beep 3 times in unison with
LED flashes then Beep for 1
second
Finger Tip Electrodes during
Recording period
Green LED flashes during 32
second recording period
None
Finger Tip Electrode
Recording complete
Green LED lit for 1 second Beep for 1 second
Pendant communicating with
Handset
Blue LED: every 4 seconds None
Holter procedure end Green and blue blink
alternately at 2Hz
None
Pendant power down All three LEDs simultaneously
every 1.5 seconds
Beep 3 times in unison with
lit LEDS.
Error Indicators
Pendant Action Visual Indicator Audible Indicator
Pendant configuration wrong
Blink all three LEDs 5 times
for 0.5 seconds every second
Beep 5 times in unison with
lit LEDs
New Holter procedure
power-
up – running cradle and lead-
on/lead-off tests.
Green blinks twice and blue
blinks once repetitively
None
New Holter procedure
power-up, low main battery
error detected.
Orange LED blinks fast None
SYMPTOM button pressed,
Pendant not in cradle
3 slow Green flashes, then
Green LED flashing fast
3 beeps then none
SYMPTOM button pressed
while Pendant creating a
Green LED Flash Long beep
Tele  Patch™ Cardiac Monitor PM750
USER MANUAL - UTM0000701-05E 
| APRIL 4, 2019
62