Medin NC3 - Components of the rest of the CPAP system

medin Medical Innovaons GmbH
Adam-Geisler-Str. 1
82140 Olching, Germany
+49 8142 448 460
info@medin-medical.com
www.medin-medical.com
IFU_medin-NC3 EN
Rev 05 Status as of 28.04.2021
48 of 68
7.2 Components of the rest of the CPAP system
The medin-NC3® must be used in combinaon with the Medijet® nCPAP generator and the appropriate accessories
(bonnets, masks, prongs and tube circuit sets).
Warmed and humidied Nuow® nasal cannulas (High Flow therapy) can also alternavely be connected in the
corresponding (High Flow) mode.
For more specic informaon on this, visit the homepage www.medin-medical.com.
Warning:
The medin-NC3® can only be operated in combinaon with the Medijet® nCPAP generator and the appropriate
tube circuit sets, bonnets, masks and prongs. If used with any other nCPAP generator, the funconality of the
device cannot be ensured, the correct alarm funcon cannot be guaranteed, sucient CPAP pressure will not be
generated and apnea detecon will not work.
The correct mode must be selected for the accessory connected in each case. Nasal cannulas may not be used in
CPAP mode and Apnea CPAP mode and the Medijet® may not be operated in High Flow mode.