Medin NC3 - History of the Software Versions and Hardware Changes

Soware version Hardware changes Descripon
SW version V 1.01 /
A.12.00 together with
display macro version
V101
First series version First version
SW version V 1.10 /
A.14.00 together with
display macro version
V110
First series version Change in the shutdown behavior: mulstage
query
Faster calculaon of the mean pressure
values in NIPPV
Opmizaon of the Leak-Assist and change
in the minimal total ow from 3 L/min to
4 L/min
Reading the pneumac self-test in the service
menu
The message “Device error – device
shutdown necessary” is triggered more
rarely; instead, the message “Press alarm
reset to restart ow” is iniated. This change
within the emergency program enables more
connuous applicaon of the nCPAP therapy
with the medin-NC3®.
White informaon signal now blinks
when the baery is being charged and is
connuously lit when the power supply unit
is connected
Pneumac system Oxygen valve 2871 replaced with a variant
with idencal construcon
External baery compartment Hand knurl replaced by rounded head screw
Blower cable Longer: 300 mm instead of 200 mm
DC port New variant
Pneumac system Measuring aperture replaced by a laminar
ow element, addional diode as a protecve
funcon
Packaging label Addion of LOT
Reinforcing bracket for housing Installaon of reinforcing bracket on hood
Fan Fan MFB60D05A replaced by
PLB60B05FSE35A
Glass front More adherent adhesive tape
medin Medical Innovaons GmbH
Adam-Geisler-Str. 1
82140 Olching, Germany
+49 8142 448 460
info@medin-medical.com
www.medin-medical.com
IFU_medin-NC3 EN
Rev 05 Status as of 28.04.2021
68 of 68
14 History of the Soware Versions and Hardware Changes
The soware of the medin-NC3® consists of various soware packets: part of them determines the operang
properes of the medin-NC3®, the alarms and the funconal range. The display macro version establishes the
possible display languages. In doing so, each SW version is dependent on a parcular version of the display macro.