Megmeet MV820 - Page 258

258
When you rotate “ ” clockwise, the function code displays the switched parameter number, only RAM modified and
not save to EEPROM.
P16.03
LED parameter display selection at stop
0 to 0xFFFF
0x3
0: No display
1: Display
Used to set whether a parameter is displayed on the zero level of the keypad menu at stop. Bit0 to bit15 correspond to
16 parameters listed in P16.04.
Note: If all is set to 0, the reference frequency will be displayed.
P16.04
LED default parameter display at stop
0 to 15
0
Used to set the default parameter number displayed on the zero level of the keypad menu at stop after power-on.
0: Reference frequency
1: Bus voltage
2: DI input status 1
3: DI input status 2
4: DO output status
5: AI1 input voltage
6: AI2 input voltage
7: AO1 output percentage
8: HDI reference frequency
9: HDO1 output
10: HDO2 output
11: Length
12: Simple PLC current step
13: Line speed
14: PID reference
15: Torque reference