Megmeet MV820 - Page 4

4
 When carrying the drive, protect the operating panel and the cover against any stress. Failure to comply will result
in personal injuries or equipment damage.
 Install the product on the place that can bear the weight. Failure to comply will result in personal injuries or
equipment damage.
 Do not install the drive near water pipes or other places with water splash. Otherwise, there will be equipment
damage.
 Take care not to drop screws, gaskets, metal bars and the like into the drive. Otherwise, fire and equipment
damage may occur.
 If the drive is damaged or lack of components, do not run the drive. Failure to comply will result in a fire or personal
injuries.
 Do not install the product in the place exposed to direct sunlight. Otherwise, there will be equipment damage.
 Do not short terminal + and (-). Otherwise, fire and equipment damage may occur.
 Cable lugs must be firmly connected to main circuit terminals. Otherwise, there will be equipment damage.
 Do not connect 220 V AC input to control terminals other than RA, RB and RC. Otherwise, there will be equipment
damage.