3 Performance specifications
10
Program phase Description
3. Sterilization phase The sterilization phase begins as soon as the pressure and temperature correspond to the
program-dependent nominal values. The sterilization time is indicated on the display.
4. Pressure release The end of the sterilization phase is followed by pressure release with simultaneous
emptying.
5. Drying phase The drying phase begins after the pressure release.
Program overview
Main menu
P
P
P
Initial state
hh:mm:ss
0.00 bar 89°C
Quick-Program S
134°C unwrapped
Universal-Program S
134°C wrapped
Prion-Program S
134°C wrapped 20'
+
-
Function
(see next page)
AIN6: Conductivity
10 µS/cm
Press 1x
Release
-
h
-
-
AIN4: Temp_pre-heat.
120°C
Press 2x
Release
h
START
Program run
Immediate removal
Press 'Stop'
Quick-Program S
run successfully
Last batch number x
Acknow. with '+' key
S
S
S
S
S+
Additional drying
selected
-------- Program running --------
Cancel program?
'Stop' key
Drying
aborted
Abort during
drying
Cancel program?
'Stop' key
Program
aborted
Pressure release
1.52 bar 112°C
Stop / End
0.02 bar 88°C
Acknowledge
with '-' key
Unlock door
with '+' key
Abort before
drying
+
-
Press simultaneously to navigate to the
SETUP menu > Function
-
h
Select by holding the '-' key depressed
+
Unlock the door with the '+' key
S+
Press the 'S' and '+' keys simultaneously
S
'Start/Stop' key and program abort
P
Program key: Enter, confirm, entry
To Next Page
Loading...
