6 First steps
28
Opening and closing the door
Opening the door
After the end of a program, the request Acknow. with '+' key is displayed.
1. Unlock the door with the '+' key.
Ê The door unlocks audibly.
PLEASE NOTE
The door can only be opened when the twist grip is fully turned by 90°.
If it was unintentionally attempted to open the door while the door was still locked, the twist grip must first be
turned back until the groove is perpendicular to the longitudinal axis. Only then the door can be opened again
using the '+' key. Otherwise the locking mechanism jams.
2. Turn the twist grip 90° counter-clockwise to open the door.
A small resistance can be felt just before the stop.
3. Push the door all the way back.
Ê If an output medium is connected and Log output YES is set, there is also a log output.
Close the door
NOTICE
Never push the door down while pulling it closed.
The door seal may fold down or be damaged.
The result may be a leaking sterilization chamber as well as a subsequent malfunction message.
1. Pull the door forward by the twist grip as far as it will go.
2. To close the door, turn the twist grip 90° clockwise.
In correctly locked condition, the groove in the twist grip must be
perpendicular to the longitudinal axis as shown.
To Next Page
Loading...
