MELAG MELAquick 12+ - First Steps: Setup and Connections; Feed Water Supply Options; Connecting Feed and Wastewater Containers

6 First steps
23
6 First steps
Setup and installation
Record of installation and setup
The responsible stockist is to complete the record of installation and setup as proof of the correct setup, installation and
commissioning. A copy is to be sent to MELAG. This is a constituent part of any guarantee claim.
Feed water supply
Steam sterilization requires the use of }distilled or }demineralized water, known as }feed water. Annex C of }EN13060
specifies the guideline values to be observed.
The feed water supply is effected either via the external feed water container or via a water treatment unit (e.g.
MELAdem40/MELAdem47).
The external feed water container has a capacity of 5 l; depending on the program selected, it is sufficient for approx. 20
sterilization cycles. The maximum water requirement of a program run amounts to 280ml.
A water treatment unit is connected to the domestic water supply. It produces the feed water which the steam sterilizer
requires for steam generation. The use of a water treatment unit guarantees the availability of sufficient feed water. You
no longer have to manually fill the feed water container.
Connections required
Connecting the feed container and wastewater container
Place the feed water container and wastewater container below the device, in the immediate vicinity and freely accessi-
ble.
The length of the inlet and outlet hoses and the cables is 1.5m. The hoses can be cut to the desired length during instal-
lation. If required, hoses as well as cables for the water containers up to max. 5 m can also be ordered and used.
CAUTION
Danger of scalding
Hot steam can escape at the rear or, when feed water is drawn in, air can enter the lines and impair the
function of the steam sterilizer.
n Insert both hoses into the couplings as far as they will go.
PLEASE NOTE
Fit the outlet hose at a constant decline without kinks or sagging. In case of deviations to the
installation arrangements, consult with MELAG.
Failure to do so can result in malfunctions of the device.