DRIVE SHAFT HOUSING
SERVICE MANUAL NUMBER 28
90-863160 MAY 2000 Page 3A-27
d. Pull oil seal and bushing into place by turning screw clockwise until tool bottoms out
on casting. (Top and Bottom).
22223
22459
e. Loosen screw and remove tool.
2. Install shift shaft upper bushings as follows:
a. Install bushing into bore so that bushing is flush with bottom of bore, as shown.
22223
22459
a
a-Bushing
3. Assemble yoke and shift cam assembly. Coat contact surfaces with gear lube.
To Next Page
Loading...
